Ga door naar hoofdinhoud

Wijzigingen in deze stap

Bewerking door Travis Tonder

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] To make sure your brake pads are seated properly when the break leaverslevers are pulled, you will need the brake pads loose enough to move them by hand but tight enough so they don't move after you adjust them.
[* black] Fold a piece of paper 2-3 times and slip it under the side of the brake pad that contacts the rim first when the wheel is rotating. thisThis will stop squeaky brakes.
[* black] To make sure your brake pads are seated properly when the break leaverslevers are pulled, you will need the brake pads loose enough to move them by hand but tight enough so they don't move after you adjust them.
[* black] Fold a piece of paper 2-3 times and slip it under the side of the brake pad that contacts the rim first when the wheel is rotating. thisThis will stop squeaky brakes.
[* black] With the paper still in between the rim and pad, lightly pull the brake lever.
[* black] Position the brake pad so it is not rubbing on the rubber tire. Angle the pad so it sits flat on the rim.
[* black] With the brake pad in its correct position, pull the brake lever as hard as you can while tightening the nut on the brake pad. Check to see if the pad is still not rubbing on the tire and is still flat on the rim.
[* black] Repeat for the brake pad on the other side.