Ga door naar hoofdinhoud

Wijzigingen in stap #3

Bewerken voor Jonathan Fish

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Shift the rear derailleur into the lowest largest(largest) gear.
[* black] The adjustment screw that corresponds to the largest gear (low gear) is labeled L.

[* red] Use the adjustment screw to alignAlign the rear guide sprocket onof the derailleur with the largest gear onlowest (largest) gear, by tightening or loosening the cassettescrew labeled "L".
[* black] Shift the rear derailleur into the lowest largest(largest) gear.
[* black] The adjustment screw that corresponds to the largest gear (low gear) is labeled L.

[* red] Use the adjustment screw to alignAlign the rear guide sprocket onof the derailleur with the largest gear onlowest (largest) gear, by tightening or loosening the cassettescrew labeled "L".
[* yellow] The second picture is of a misaligned derailleur.
[* icon_note] This alignment sets the maximum inward distance that the derailleur can move the chain. Without setting this boundary, the derailleur could shift the bike chain off of the gear and onto the axle. This boundary setting is referred to as the low end adjustment stop.