Ga door naar hoofdinhoud

Wijzigingen in stap #6

Bewerken voor Jonathan Fish

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* red] Fine tune the derailleur usingby tightening or loosening the barrel adjuster screw located where the cable and cable housing meet the derailleur.
[* red] Fine tune the derailleur usingby tightening or loosening the barrel adjuster screw located where the cable and cable housing meet the derailleur.
[* black] Shift through each gear while pedaling. The derailleur should move one gear every time you shift up or down on the shifter.
[* black] If the chain skips or makes noise when not shifting, use the barrel adjustment screw to position the guide sprocket so it is right under the gear that corresponds to the number the shifter displays.
[* black] Repeat the previous steps until the derailleur shifts smoothly and makes a minimal amount of noise.
[* icon_note] Loosening the barrel adjuster screw pulls in the cable, causing the derailleur to move slightly towards a larger gear. Tightening causes the derailler to move towards a smaller gear.