Ga door naar hoofdinhoud

Wijzigingen in stap #6

Bewerken voor Jonathan Fish

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] fine tune the derailleur Using the barrel adjuster screw located where the cable and cable housing meet the derailleur.
[* black] shift through each gear while pedaling. the derailleur should move one gear every time you shift up or down on the shifter.
[* blackicon_note] if the chain skips or makes noise when not shifting, Use the barrel adjustment screw to position the guide sprocket so it is right under the gear that corresponds to what number the shifter displays.
[* blackicon_note] Loosening the barrel adjuster screw will effectively pullpulls in the cablecable, causing the derailleur to move slightly totowards a larger gear and vis-versagear. Tightening causes the derailler to move towards a smaller gear.
[* black] Repeat the previous stepsteps until the derailleur shifts smoothly and makes a minimal amount of noise.
[* blackicon_note] if the chain skips or makes noise when not shifting, Use the barrel adjustment screw to position the guide sprocket so it is right under the gear that corresponds to what number the shifter displays.
[* blackicon_note] Loosening the barrel adjuster screw will effectively pullpulls in the cablecable, causing the derailleur to move slightly totowards a larger gear and vis-versagear. Tightening causes the derailler to move towards a smaller gear.
[* black] Repeat the previous stepsteps until the derailleur shifts smoothly and makes a minimal amount of noise.