Ga door naar hoofdinhoud

Wijzigingen in stap #2

Bewerken voor Jonathan Fish

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Adjust the low end adjustment stop.
[* black] The adjustment screw that corresponds to the smallest gear (high gear) is labeled H.
[* black] Tightening the screw will push
-Shift the rear derailleur inwards and loosening it will pushinto the derailleur outwardshighest (smallest) gear.
[* red] Use the adjustment screw to align-Align the rear guide sprocket onof the derailleur with the smallest gear onhighest (smallest) gear, by tightening or loosening the cassettescrew labeled "H".
[* black] Adjust the low end adjustment stop.
[* black] The adjustment screw that corresponds to the smallest gear (high gear) is labeled H.
[* black] Tightening the screw will push
-Shift the rear derailleur inwards and loosening it will pushinto the derailleur outwardshighest (smallest) gear.
[* red] Use the adjustment screw to align-Align the rear guide sprocket onof the derailleur with the smallest gear onhighest (smallest) gear, by tightening or loosening the cassettescrew labeled "H".
[* yellow] The second picture is of a misaligned derailleur.
[* icon_note] Note:This alignment sets the maximum outward distance that the derailleur can move the chain. Without setting this boundary, the derailleur could shift the bike chain off of the sprocket and onto the axle. This boundary setting is referred to as the high end adjustment stop.