Ga door naar hoofdinhoud

Wijzigingen aan stap #8

Bewerking door Pete H

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] Reveal plug in to inverter board
[* black] Use small hemostat or tweezers to grasp end of inverter plug in and pull out.
[* black] The LCD is now free to be removed.
[* black] To install an inverter just lift the cover up higher and remove it.
+[* black] I was able to leave the left end of the clutch cover 'mostly' in place and unplug both ends of the inverter.
+[* black] When replacing the clutch cover inspect the back. I had both ends 'sticking out' a little and had to break the little plastic tabs to make it flush again - or I could have started over and removed everything to properly replace the clutch cover. On a 5 year-old machine I elected to break plastic tabs off the clutch cover.