Ga door naar hoofdinhoud

Wijzigingen aan stap #7

Bewerking door jffwckzr

Bewerking geweigerd door David Hodson

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Insert the edge of an iPod opening tool under the steel mid plane near the bottom left corner of the Touch.
[* black] Pry upward to separate the plate from the adhesive securing it to the plastic inner case.
[* icon_caution] Use extreme care, the speaker is under the area shown in photo. It is connected with very thin and short wires.
[* orange] There is a very thin ribbon cable here that connects the volume and power buttons to the logic board. Try to work around this area like shown so not to rip the cable. It is extremely fragile. Also note that the logic board may stick to the steel mid plane.
[* orange] There is a very thin ribbon cable here that connects the volume and power buttons to the logic board. Try to work around this area like shown so not to rip the cable. It is extremely fragile. Also note that the logic board may stick to the steel mid plane.
[* icon_caution] This cable will tear very easily if you are not careful.
[* black] To get a better idea of where the cable is, click "View Huge" on the top left of the image.