Ga door naar hoofdinhoud

Wijzigingen aan stap #7

Bewerking door beasleybiz

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Insert the edge of an iPod opening tool under the steel mid plane near the bottom left corner of the Touch.
[* black] Pry upward to separate the plate from the adhesive securing it to the plastic inner case.
[* icon_caution] Use extreme care, the speaker is under the area shown in photo. It is connected with very thin and short wires.
[* orange] There is a very thin ribbon cable here that connects the volume and power buttons to the logic board. Try to work around this area like shown so not to rip the cable. It is extremely fragile. If you see the ribbon cable starting to pull up stop prying and reheat the area with your heat gun as the logic board may be adhered to the metal plate.
[* orange] There is a very thin ribbon cable here that connects the volume and power buttons to the logic board. Try to work around this area like shown so not to rip the cable. It is extremely fragile. If you see the ribbon cable starting to pull up stop prying and reheat the area with your heat gun as the logic board may be adhered to the metal plate.