Ga door naar hoofdinhoud

Wijzigingen aan stap #2

Bewerking door Andrew Bookholt

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_caution] Before proceeding, make sure thatBeware, as the Touch has cooled down sufficiently enoughwill be very hot. It may be helpful to prevent any possible burnshold it with a towel while prying.
[* black] WedgeInsert the edge of an iPod opening tool between the front glass panel and the black plastic bezel near the lower right corner ofhome button.
[* icon_caution] Do not try to pry between
the Touchblack plastic bezel and the steel rear case.
[* black] Run the opening tool alongPry the bottom edge of the Touch from rightfront panel upward, being careful not to leftbend the glass excessively.
[* icon_note] If it is too difficult to pry up the front panel assembly, reheat it and try again
.
[* icon_caution] Before proceeding, make sure thatBeware, as the Touch has cooled down sufficiently enoughwill be very hot. It may be helpful to prevent any possible burnshold it with a towel while prying.
[* black] WedgeInsert the edge of an iPod opening tool between the front glass panel and the black plastic bezel near the lower right corner ofhome button.
[* icon_caution] Do not try to pry between
the Touchblack plastic bezel and the steel rear case.
[* black] Run the opening tool alongPry the bottom edge of the Touch from rightfront panel upward, being careful not to leftbend the glass excessively.
[* icon_note] If it is too difficult to pry up the front panel assembly, reheat it and try again
.