Ga door naar hoofdinhoud

Wijzigingen aan stap #1

Bewerking door Ryan

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_note] The iPod Touch 4th Generation front panel is attached to the rear case by adhesive. The use of a heat gun to soften the adhesive is highly recommended.
[* black] With the heat gun set on "low", begin heating the lower portion of the Touch near the home button. Be careful the plastic home button does not melt!
[* black] With the heat gun set on "low", begin heating the lower portion of the Touch near the home button. Be careful the plastic home button does not melt!
[* icon_reminder] It is suggested to heat the desired portion in a circular motion pattern to evenly dissipate the amount of heat throughout the device.