Ga door naar hoofdinhoud

Wijzigingen aan stap #14

Bewerking door Andrew Bookholt

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* red] After wrangling the logic board/battery/display assembly out of the rear panel, we can finally access the screws holding the volume button cover and the sleep button down.
+[* black] After a good bit of anxiety-filled scraping with a metal spudger, the ribbon cable is finally free from the rear panel.
+ [* icon_note] The control ribbon cable is bonded to the rear panel extremely well, especially near the volume buttons. Since the volume buttons have no structural bracket (just a steel cover) holding them to the rear panel, the adhesive bond must be strong enough to survive presses from the strongest of button pushers.

Afbeelding 3

Geen vorige afbeelding

Toegevoegd