Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #6

Bewerking door Andrew Bookholt

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] Insert a machine screw through each of the four holes around the CPU heat sink, with their heads on the back side of the board.
[* black] While holding the head of the screw, place a nylon washer '''then''' a metal washer over the threads.
[* icon_caution] The order of the washers is important. '''Do not''' put the metal washer on first.
[* red] Using the large flathead screwdriver bit, thoroughly tighten the screws into the CPU heat sink.
[* icon_note] On newer models, it is normal to have
Don't be afraid of over-tightening the screws slightly bend the lower fins on the CPU heat sink upward when they are fully tightened. This '''will not''' cause cooling issues and poses no risk to the motherboardscrews.
[* red] Using the large flathead screwdriver bit, thoroughly tighten the screws into the CPU heat sink.
[* icon_note] On newer models, it is normal to have
Don't be afraid of over-tightening the screws slightly bend the lower fins on the CPU heat sink upward when they are fully tightened. This '''will not''' cause cooling issues and poses no risk to the motherboardscrews.
[* icon_caution] When attaching the CPU heat sink, be sure the fins are aligned with the air flow from the fans (as seen in the third picture). Having the flat side of the fins perpendicular to the air flow will cause your Xbox 360 to overheat.
[* icon_reminder] Repeat the same process to attach your GPU heat sink.