Ga door naar hoofdinhoud

Wijzigingen in stap #9

Bewerken voor iRobot

Wachtend op goedkeuring


Stap regels

[* icon_reminder] Important. when you reinstall a logic board, you'll need to replace the thermal paste that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer.
[* black] Use a firm plastic edge to scrape the thermal material off the heat sink .
[* black] Apply a new layer of thermal paste to the heat sink

Afbeelding 1

Geen vorige afbeelding