Ga door naar hoofdinhoud

Wijzigingen in stap #3

Bewerken voor Walter Galan

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_reminder] To reinstall the xX clamp, first start by attaching two corners to the posts on the heat sink.
[* icon_reminder] While holding the third arm of the xX clamp down against the post attached to the heat sink, use a small flathead screwdriver to pry the xX clamp away from the heat sink post.
[* icon_reminder] As you pry, press down on the arm of the xX clamp until you "walk" it down into the retaining groove cut into the post attached to the heat sink.
[* icon_note] Repeat this process for the fourth arm of the xX clamp.
[* icon_reminder] To reinstall the xX clamp, first start by attaching two corners to the posts on the heat sink.
[* icon_reminder] While holding the third arm of the xX clamp down against the post attached to the heat sink, use a small flathead screwdriver to pry the xX clamp away from the heat sink post.
[* icon_reminder] As you pry, press down on the arm of the xX clamp until you "walk" it down into the retaining groove cut into the post attached to the heat sink.
[* icon_note] Repeat this process for the fourth arm of the xX clamp.