Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #11

Bewerking door Nicolas Siemsen

Bewerking goedgekeurd door Nicolas Siemsen

Voor
Na
Ongewijzigd

Stap regels

[* black] Next, proceed by removing all of the cables that connect to the DMD board.
[* green] At the upper right edge there is a small ribbon cable that pulls straight up to remove, and two other cables that connect with cable ends that clip in to the small plugs. Remove these three cables carefully.
[* blacklight_blue] Next, remove the three cables on the right end of the DMD board. The two upper are fan power cables, and the lower connects to the light bulb controls.
[* violet] Finally, remove the lower most cable that connects to the bottom left corner of the DMD board.
[* blacklight_blue] Next, remove the three cables on the right end of the DMD board. The two upper are fan power cables, and the lower connects to the light bulb controls.
[* violet] Finally, remove the lower most cable that connects to the bottom left corner of the DMD board.

Afbeelding 3

Oude versie

Nieuwe versie