Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #12

Bewerking door Sam Goldheart

Bewerking goedgekeurd door Sam Goldheart

Voor
Na
Ongewijzigd

Stap regels

[* black] Removered] Remove the following screws securing the logic board to the rear case:
[* red] Two 1.9
single 1.2 mm Phillips #000 screws
[* orange] One 2.3 mm standoff
screw
[* icon_note] Use a small flathead screwdriver to remove these standoff screws.
[* icon_reminder] During reassembly, you can use
securing the tip of a spudgerantenna interconnect cable to get the standoff screw startedlogic board.
[* black] Removered] Remove the following screws securing the logic board to the rear case:
[* red] Two 1.9
single 1.2 mm Phillips #000 screws
[* orange] One 2.3 mm standoff
screw
[* icon_note] Use a small flathead screwdriver to remove these standoff screws.
[* icon_reminder] During reassembly, you can use
securing the tip of a spudgerantenna interconnect cable to get the standoff screw startedlogic board.

Afbeelding 1

Oude versie

Nieuwe versie