Ga door naar hoofdinhoud

Wijzigingen aan stap #4

Bewerking door Richdave

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* green] Disconnect the upper fan connector from the logic board
[* red] Remove the 4 spring loaded screws holding the heat sink assembly to the logic board
[* icon_note] When reassembling, thread all screws in a1 -1 1/2 turns then alternately tighten each screw 1 turn - starting top left, then bottom right, then bottom left, then top left again etc. until the heat sink assembly is firmly seated and all screws are tightened the same amount.