Ga door naar hoofdinhoud

Wijzigingen aan stap #4

Bewerking door Jacob Pugsley

Bewerking goedgekeurd door Jacob Pugsley

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* red] Disconnect the upper fan connector from the motherboard.
[* orange] Remove the 4four spring loaded screws holding the heat sink assembly to the motherboard.
[* icon_note] When reassembling, threadensure that all the screws in 1 - 1 1/2 turnsare equally tightened: thread all screws one turn, then alternately tightenadd one turn to each screw 1 turn - startingin the following order: top left, then bottom right, then bottom left, then top right, then top left again etc.right. Repeat this order until the heat sink assembly is firmly seated and all screws are tightened the same amountseated.
[* orange] Remove the 4four spring loaded screws holding the heat sink assembly to the motherboard.
[* icon_note] When reassembling, threadensure that all the screws in 1 - 1 1/2 turnsare equally tightened: thread all screws one turn, then alternately tightenadd one turn to each screw 1 turn - startingin the following order: top left, then bottom right, then bottom left, then top right, then top left again etc.right. Repeat this order until the heat sink assembly is firmly seated and all screws are tightened the same amountseated.