Skip to main content

Wijzigingen aan stap #4

Bewerking door I M Geek

Bewerking goedgekeurd door Adam O'Camb

Verwijderd
Toegevoegd
Ongewijzigd

Stapregels

[* red] Disconnect the upper fan connector from the motherboard.
[* orange] Remove the 4 spring loaded screws holding the heat sink assembly to the motherboard.
[* icon_note] When reassembling, thread all screws in 1 - 1 1/2 turns then alternately tighten each screw 1 turn - starting top left, then bottom right, then bottom left, then top right, then top left again etc. until the heat sink assembly is firmly seated and all screws are tightened the same amount.
[* icon_note] When reassembling, thread all screws in 1 - 1 1/2 turns then alternately tighten each screw 1 turn - starting top left, then bottom right, then bottom left, then top right, then top left again etc. until the heat sink assembly is firmly seated and all screws are tightened the same amount.