Ga door naar hoofdinhoud

Wijzigingen aan stap #4

Bewerking door Marty Rippens

Bewerking goedgekeurd door Marty Rippens

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* greenred] Disconnect the upper fan connector from the motherboard.
[* redorange] Remove the 4 spring loaded screws holding the heat sink assembly to the motherboard.
[* greenred] Disconnect the upper fan connector from the motherboard.
[* redorange] Remove the 4 spring loaded screws holding the heat sink assembly to the motherboard.
[* icon_note] When reassembling, thread all screws in 1 - 1 1/2 turns then alternately tighten each screw 1 turn - starting top left, then bottom right, then bottom left, then top left again etc. until the heat sink assembly is firmly seated and all screws are tightened the same amount.

Afbeelding 1

Oude versie

Nieuwe versie