Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #10

Bewerking door Sam Goldheart

Bewerking goedgekeurd door Sam Goldheart

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_note] Open the MacBook Pro a little wider than 90 degrees, and place it on-endon end on the table, as shown.
[* black] While holding the display and upper case together with your left hand, remove the remaining T8 Torx screw from the upper display bracket.
[* icon_caution] Be sure to hold the display and upper case together with your left hand. Failure to do so may cause the freed display/upper case toare balanced and will not fall, potentially damaging each component.
[* icon_note] Open the MacBook Pro a little wider than 90 degrees, and place it on-endon end on the table, as shown.
[* black] While holding the display and upper case together with your left hand, remove the remaining T8 Torx screw from the upper display bracket.
[* icon_caution] Be sure to hold the display and upper case together with your left hand. Failure to do so may cause the freed display/upper case toare balanced and will not fall, potentially damaging each component.
[* black] Remove the last remaining T8 Torx screw securing the display to the upper case.