Ga door naar hoofdinhoud

Wijzigingen in stap #8

Bewerken voor Mikel Sangroniz

Bewerking goedgekeurd door Mikel Sangroniz

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Insert athe flat end of a spudger into athe thin crack running along the side of the laptop. Gently pry open along the perimeter of the laptop to remove the base.
[* icon_note] You can lay the back panel flat against the surface you are working on to make the task less cumbersome.
[* black] Insert athe flat end of a spudger into athe thin crack running along the side of the laptop. Gently pry open along the perimeter of the laptop to remove the base.
[* icon_note] You can lay the back panel flat against the surface you are working on to make the task less cumbersome.
[* black] After completely prying the two bases from each other, set the top base flat against the back panel, revealing the circuit board.