Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #10

Bewerking door Jeff Suovanen

Bewerking goedgekeurd door Jeff Suovanen

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Switch on your multimeter, and set the dial to DC voltage mode (indicated by a V with a straight line, or the symbol ⎓).
[* icon_note] Virtually all consumer electronic devices run on DC voltage. AC voltage—the kind that runs through the lines to your house—is considerably more dangerous, and beyond the scope of this guide.
[* black] Most multimeters are not autoranging, meaning you will need to set the correct range for the voltage you intendexpect to measure.
[* black] Each setting on the dial lists the maximum voltage it can measure. So for example, if you expect to measure more than 2 volts but less than 20, use the 20 volt setting.
[* black]
If you're not sure, start with the highest rangesetting.
[* black] Most multimeters are not autoranging, meaning you will need to set the correct range for the voltage you intendexpect to measure.
[* black] Each setting on the dial lists the maximum voltage it can measure. So for example, if you expect to measure more than 2 volts but less than 20, use the 20 volt setting.
[* black]
If you're not sure, start with the highest rangesetting.