Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #13

Bewerking door Jeff Suovanen

Bewerking goedgekeurd door Jeff Suovanen

Voor
Na
Ongewijzigd

Stap regels

[* black] Add 2 lengths of shrink-tube on the 2 wireswires.
[* black] Now, solder the 4 wires together
[*
together.
[*
icon_caution] Make sure to connect white to white, and black to the bear metalled one
[*
bare metal one.
[*
icon_note] Make sure to do this step really quickly, as the heat-shrink tube will contract from the heat of the soldering
[*
soldering.
[*
black] Alternatively, you could just use duct tape - justtape—just be careful so it doesn't slide off when you're bending the wireswires.
[* black] Move the shirk-tube over the soldering spots, and heat it up (mineup. (Mine fell a bit short, so I did end up using a bit of duct tapetape.)
[* black] Add 2 lengths of shrink-tube on the 2 wireswires.
[* black] Now, solder the 4 wires together
[*
together.
[*
icon_caution] Make sure to connect white to white, and black to the bear metalled one
[*
bare metal one.
[*
icon_note] Make sure to do this step really quickly, as the heat-shrink tube will contract from the heat of the soldering
[*
soldering.
[*
black] Alternatively, you could just use duct tape - justtape—just be careful so it doesn't slide off when you're bending the wireswires.
[* black] Move the shirk-tube over the soldering spots, and heat it up (mineup. (Mine fell a bit short, so I did end up using a bit of duct tapetape.)