Ga door naar hoofdinhoud

Wijzigingen aan stap #11

Bewerking door Alexander

Bewerking goedgekeurd door Alexander

Voor
Na
Ongewijzigd

Stap regels

[title] Solder the battery holder
[* black] Place a heavy object on the board to keep it from sliding around on the table.
[* yellow] Rest the iron between the extruding battery holder tab and the corresponding solder padpad to begin heating them up.
[* yellow] Rest the iron between the extruding battery holder tab and the corresponding solder padpad to begin heating them up.
[* icon_note] The junction will not heat up immediately. It is necessary to hold the iron in place for about 20-30 seconds before sufficiently hot.
[* icon_note] Applying pressure to the junction, as opposed to simply laying the iron, will improve heat conductivity. This will speed up the process and result in a better solder joint.