Wijzigingen aan stap #2
Bewerking door iRobot —
- Voor
- Na
- Ongewijzigd
Stap regels
| [* icon_note] There should be no cables connected to the top of the logic board at this point. |
| [* black] Remove the following 12 Phillips screws from the logic board: |
| [* red] Six 4 mm around the edges of the logic board. |
| [* orange] Two 5 mm securing the right speaker to the logic board (move the speaker off of the logic board). |
| [* yellow] Three 6 mm with wavy washers in the upper, left corner of the logic board. |
| [* green] One 4 mm underneath a black bumper in the back right corner of the logic board. |
| [* blue] One 4 mm screw may not be present on some logic boards. |
Afbeelding 1
Geen vorige afbeelding
Toegevoegd