Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #22

Bewerking door David Hodson

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* icon_caution] The digitizer ribbon cable is '''extremely''' delicate. We're not joking on this. It's about the thickness of a human hair. Proceed with caution.
[* black] Use the edge of an iPoda plastic opening tool to carefully lift the digitizer ribbon cable off the two positioning pegs on the inner case.
[* black] Use the edge of an iPoda plastic opening tool to carefully lift the digitizer ribbon cable off the two positioning pegs on the inner case.
[* black] Remove the following screws securing the inner case to the front case:
[* red] Four 6.3 mm Phillips
[* orange] Two 3 mm Phillips
[* black] Pull the same retaining tab used to secure the logic board away from the center of the Newton to release the inner case, then pull it away from the bottom of the Newton and set it aside.