Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #3

Bewerking door Taylor Arnicar

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Peeling up yellow tape as necessary, remove the following 8 screws:
[* red] One 4.5 mm Phillips on the right side of the heat sink.
[* orange] Three 6 mm Phillips near the display.
[* yellow] Two large 7.5 mm Phillips with springs (don't forget to remove the springs) This may be the most difficult task ifsprings). If the springs are not releasing the Phillips. Needlereleasing, needle nose pliers can help get this done.
[* yellow] Two large 7.5 mm Phillips with springs (don't forget to remove the springs) This may be the most difficult task ifsprings). If the springs are not releasing the Phillips. Needlereleasing, needle nose pliers can help get this done.
[* green] Two 13 mm screws from the left side of the heat sink and the right side of the fan.