Ga door naar hoofdinhoud

Wijzigingen in stap #7

Bewerken voor Cole O'Neal

Bewerking goedgekeurd door Adam O'Camb

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] At the other endend, 2 big flex cables are brought together by a small control board. Disconnect the 2 clips (Green - LCD and Orange - Digitizer) and,and the other ends of the antennas. Then remove the antenna wires completely.
[* black] At the other endend, 2 big flex cables are brought together by a small control board. Disconnect the 2 clips (Green - LCD and Orange - Digitizer) and,and the other ends of the antennas. Then remove the antenna wires completely.
[* black] This small control board is also held down by a little adhesive, but can be carefully pried up.
[* blackicon_note] In the third picture, marked in the Green squaresquare, is a piece of plastic that is kind of attached to the board. It is better to just pry it up with the board than disconnect it.
[* blackicon_note] In the third picture, marked in the Green squaresquare, is a piece of plastic that is kind of attached to the board. It is better to just pry it up with the board than disconnect it.