Ga door naar hoofdinhoud

Wijzigingen in stap #6

Bewerken voor klatte

Bewerking geweigerd door Evan Noronha

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Remove the following screws from the logic board:
[* red] One 2.4 mm Phillips #000 screw
[* orange] Two 2.3 mm Phillips #000 screws
[* yellow] Four 2.8 mm standoff screws
[* icon_note] Use a small flathead screwdriver (2.0) to remove these standoff screws.
[* icon_note] Use a small flathead screwdriver (2.0) to remove these standoff screws.
[* icon_reminder] During reassembly, you can use the tip of a spudger to get the standoff screw started.