Ga door naar hoofdinhoud

Wijzigingen in stap #6

Bewerken voor Jeff Suovanen

Bewerking goedgekeurd door Jeff Suovanen

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Remove the following screws from the logic board:
[* red] One 2.4 mm Phillips #000 screw
[* icon_reminder] This screw also holds a small metal contact beneath the logic board. It's held in place underneath a plastic bracket, but if you see it slipping out, refer to [guide|20246|this step|stepid=72613|new_window=true] to remove it.
[* orange] Two 2.3 mm Phillips #000 screws
[* yellow] Four 2.8 mm standoff screws
[* icon_note] UseStandoff screws are best removed with a [product|IF145-388-5|standoff screwdriver|new_window=true] or [product|IF145-343|standoff driver bit]. A small flathead screwdriver to remove these standoff screws.
[* icon_reminder] During reassembly, you
can also do the job—but use the tip of a spudgerextra caution to get the standoff screw startedensure it doesn't slip and damage surrounding components.
[* icon_note] UseStandoff screws are best removed with a [product|IF145-388-5|standoff screwdriver|new_window=true] or [product|IF145-343|standoff driver bit]. A small flathead screwdriver to remove these standoff screws.
[* icon_reminder] During reassembly, you
can also do the job—but use the tip of a spudgerextra caution to get the standoff screw startedensure it doesn't slip and damage surrounding components.