Wijzigingen aan stap #5
Bewerken voor Uchenna Oniah —
Bewerking goedgekeurd door Uchenna Oniah
- Voor
- Na
- Ongewijzigd
Stap regels
| [title] Remove Diodes | |
| - | [* black] Heat up soldering irons |
| - | [* black] Add fresh solder to both ends of the diode |
| - | [* icon_note] Hold iron onto the end of the diode and feed solder onto the board right at the tip of the soldering iron |
| - | [* black] Hold solder irons on both ends of the diode and lift the diode off of circuit board once solder melts |
| - | [* black] Repeat above steps for the remaining diodes |
| + | [* black] [link|https://youtu.be/nfXqK8jUcLc?si=Ld4pF9EEc0nQNKMb&t=143|Method 1 (1 soldering irons)|new_window=true] |
| + | [* black] Quickly move the soldering iron back and forth between both ends of the diode while adding fresh solder until the diode is released from the pads. |
| + | [* black] [link|https://youtu.be/nfXqK8jUcLc?si=je8U0GYQ80FerWJy&t=232|Method 2 (2 soldering irons)|new_window=true] [Photo 2] |
| + | [* black] Heat up both soldering irons. |
| + | [* black] Add fresh solder to both ends of the diode. (Photo 1) |
| + | [* icon_note] Hold iron onto the end of the diode and feed solder onto the board right at the tip of the soldering iron. |
| + | [* black] Hold soldering irons on both ends of the diode and lift the diode off of the circuit board once the solder melts. (Photo 2) |
| + | [* black] Repeat the above steps for the remaining diodes. |