Wijzigingen aan stap #9
Bewerken voor Nick Schultz —
Bewerking goedgekeurd door Nick Schultz
- Voor
- Na
- Ongewijzigd
Stap regels
| [title] Check your work | |
| [* icon_note] Congratulations—you've soldered the resistor to the board! | |
| [* icon_note] If one of the solder joints doesn't make contact with an end cap, reheat the cap and add more solder. If the solder isn't flowing neatly, [link|https://guide-images.cdn.ifixit.com/igi/DGShhPUERNCBDups.full|apply flux to the joint|new_window=true] before adding more solder. | |
| - | [* icon_note] Check if any solder unintentionally bridged with a different pad. If so, carefully use your iron to heat the solder between the pads and separate the bridge. If the bridge doesn't want to separate, [guide|173873|desolder it|stepid=370734|new_window=true] and try again. |
| + | [* icon_note] Check if any solder has unintentionally bridged with a different pad. If so, carefully use your iron to heat the solder between the pads and separate the bridge. If the bridge doesn't want to separate, [guide|173873|desolder it|stepid=370734|new_window=true] and try again. |