Ga door naar hoofdinhoud

Wijzigingen in stap #5

Bewerken voor Sam Goldheart

Bewerking goedgekeurd door Sam Goldheart

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Use the flat end of a spudger to lift the power supply up off the posts in the rear housing.
[* black] Lift and remove the power supply from the rear housing.
[* icon_caution] '''Be very careful''' not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges.
[* icon_reminder] During reassembly ensure that the rubber grommet on the AC power harness is in the slot in the power-supply cover.
[* icon_reminder] Ensure that the green ground wires are secured under the power-supply cover.