Ga door naar hoofdinhoud

Wijzigingen in stap #14

Bewerken voor David Hodson

Bewerking goedgekeurd door David Hodson

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Lift the side of the logic board opposite the ports out of the upper case.
[* black] Rotate the logic board away from the upper case until the ports clear the lip molded in the upper case.
[* black] Pull the logic board and DC-InMagSafe board away from the edge of the upper case as one piece.
[* icon_reminder] The DC-InMagSafe board may get accidentally disconnected during this process. As a precaution, be sure the DC-InMagSafe board connector is securely seated in its socket before lowering the logic board back into the upper case.
[* black] Pull the logic board and DC-InMagSafe board away from the edge of the upper case as one piece.
[* icon_reminder] The DC-InMagSafe board may get accidentally disconnected during this process. As a precaution, be sure the DC-InMagSafe board connector is securely seated in its socket before lowering the logic board back into the upper case.
[* icon_reminder] Before lowering the logic board back into the upper case, be sure the left speaker and microphone cables are seated in their channels cut into the upper case (as seen in the third picture).