Ga door naar hoofdinhoud

Fix Your Stuff

Right to Repair

Parts & Tools

Wijzigingen in deze stap

Bewerking door Mario Pecoraro

Bewerking geweigerd door Walter Galan

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_caution] Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive, putdrive.
[* icon_note] Remember for the reinstall. Put
the connector closest to the SATA connections and the dark wire ( on top ) closest to the PCB board. If you fan is spinning like a jet engine, chances are its this connector. Just flip it and this should fix it.
[* icon_caution] Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive, putdrive.
[* icon_note] Remember for the reinstall. Put
the connector closest to the SATA connections and the dark wire ( on top ) closest to the PCB board. If you fan is spinning like a jet engine, chances are its this connector. Just flip it and this should fix it.
[* black] Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive.