Repareer je spullen Gemeenschap Winkel

Wijzigingen aan stap #2

Bewerken voor Spencer Day —

Bewerking goedgekeurd door Spencer Day

Voor
Na
Ongewijzigd

Stap regels

-[title] Remove the midframe
-[* black] Remove the midframe.
+[title] Remove the rear shell
+[* black] Remove the rear shell.
[* icon_reminder] During reassembly:
- [* red] Thread the bumpers button board cable through its slot in the midframe.
- [* black] Lay the midframe on the frame, so its bottom edge is slightly lower than the frame.
- [* icon_note] This allows the tabs to slide into place. If the midframe is perfectly flush with the frame, the tabs won't slide.
- [* orange] Press down and slide the midframe up to engage the sliding tabs.
+ [* red] Thread the bumpers button board cable through its slot in the rear shell.
+ [* black] Lay the rear shell on the front shell, so its bottom edge slightly overhangs.
+ [* icon_note] This allows the tabs to slide into place. If the rear shell is perfectly flush with the front shell, the tabs won't slide.
+ [* orange] Press down and slide the rear shell up to engage the sliding tabs.