Ga door naar hoofdinhoud

Wijzigingen aan stap #2

Bewerking door Sam Goldheart

Bewerking goedgekeurd door Sam Goldheart

Voor
Na
Ongewijzigd

Stap regels

-[* black] Disconnect the camera cable connector out of its socket with the tip of a spudger.
-[* icon_note] It is recommended to carefully push on both sides of the connector to "walk" it out of its socket.
+[* black] Disconnect the camera cable connector with the tip of a spudger.
+[* icon_note] Push first on one side of the connector, then on the other side to carefully "walk" it out of its socket.
[* black] Pull the camera cable parallel to the face of the I/O board toward the front edge of the Air to disconnect it from its socket.
[* icon_caution] Do not lift upward on this cable as you disconnect it, as its socket may break off the logic board.