Ga door naar hoofdinhoud

Wijzigingen in stap #6

Bewerken voor Angela Penaherrera

Bewerking goedgekeurd door Angela Penaherrera

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_caution] You need to have lots of patience in this procedure. Take your time.
[* black] Hold the gun at about 3 inches from your phone (in this picture it looks like its right on top). With the heat gun set to low, heat up the borders for about 3 to 5 minutes depending on the strength of your heat gun.
[* black] You must be careful when using the heat gun on this device. If the device is heated up too much then it may melt the digitizer and cause discoloration. If you start to see any discoloration then shut off the gun immediately.
[* black] If you are working with a hair dryer, it might take up to 1 hour.
[* blackicon_caution] This melts the glue that holds the glass to the frameframe and to the display. The glass is glued to them.
[* blackicon_caution] This melts the glue that holds the glass to the frameframe and to the display. The glass is glued to them.