Ga door naar hoofdinhoud

Wijzigingen aan stap #1

Bewerking door Kyle Smith

Bewerking goedgekeurd door Kyle Smith

Voor
Na
Ongewijzigd

Stap regels

[title] Battery adhesive information
-[* icon_note] In the following steps, you will separate the battery from the adhesive securing it to the frame.
+[* icon_note] In the following steps, you'll separate the battery from the adhesive securing it to the frame.
[* red] The adhesive is laid out as shown: two strips along the long edges, and two shorter strips perpendicular in the center.
[* icon_caution] Don't pry near the logic board, as you could damage your iPad.
-[* icon_note] If you are performing this procedure on the Wi-Fi version, it's safe to insert pry tools from the upper, lower, and left edges of the battery. For the LTE version, there may be additional components under the upper edge of the battery.
+[* icon_note] If you are performing this procedure on the Wi-Fi version, it's safe to insert plastic cards from the upper, lower, and left edges of the battery (when the charging port is oriented down). For the LTE version, only insert plastic cards under the lower and left sides.

Afbeelding 1

Oude versie

Nieuwe versie

Afbeelding 2

Geen vorige afbeelding

Toegevoegd