Wijzigingen aan stap #1
Bewerken voor kjkj kjkjk —
Bewerking goedgekeurd door guardian10
- Voor
- Na
- Ongewijzigd
Stap regels
| - | [title] remove screws, open |
|---|---|
| - | [* red] Pull adhesive pads aside using scalpel, making it easier to remove 3 PH0 screws. |
| - | [* black] It is recommmended to leave the pads in place, as they can be difficult to place after the repair. They also become non sticky if they are touched too much. |
| - | [* black] Remove top part by prying with a spudger plastic tool, pulling gently to not break anything. |
| + | [title] Open the case |
| + | [* black] Flip the mouse over to gain access to the bottom. |
| + | [* red] Using a scalpel, pick, or similar tool, peel away the slide pads on the bottom of the mouse in order to expose the three screws, shown in red in the image. |
| + | [* black] Peel away as little of the pads as possible, in order to preserve the adhesive on their undersides. |
| + | [* red] Using a PH0 / Phillips #0 driver, remove the 3 screws shown in red. |
| + | [* black] Gently separate the two halves of the case. Light prying may be required. |
| [* black] For PCB removal : remove 3 PH0 screws from PCB surface. The whole PCB can be taken out for inspection and repair after the screws are removed. |