Ga door naar hoofdinhoud

Wijzigingen in deze stap

Bewerking door Kevin Hua

Bewerking goedgekeurd door Kevin Hua

Voor
Na
Ongewijzigd

Stap regels

-[* red] Continue to remove the back by removing the 10 T5 Torx screws located underneath the kickstand
-[* orange] Remove the 7 T5 Torx screws located under the camera casing.
-[* yellow] Now you will be taking off the back plate from the main system. Read the caution below before reading on. Begin loosening the back-plate with a spudger where gaps exist (example in picture)
-[* icon_caution] Caution: There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosen the back plate from the main system.
-[* green] Continue working your way around to each corner and loosen the snap-ons on each side. Note: You will have to patiently pry the back-plate open.
+[* red] Continue to remove the back by removing the 10 T5 (5.92 mm) Torx screws located underneath the kickstand
+[* orange] Remove the 7 T5 Torx (5.87 mm) screws located under the camera casing.
+[* yellow] Now you will be taking off the back plate from the main system. Begin loosening the back-plate with a spudger where gaps exist.
+[* icon_caution] There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosen the back plate from the main system.
+[* icon_note] Continue working your way around to each corner and loosen the snap-ons on each side until the back plate comes off.