Ga door naar hoofdinhoud

Wijzigingen in stap #9

Bewerken voor David Hodson

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] The front bezel is attached to the camera's chassis by a number of easy to release tabs.
[* black] Using a spudger or iPodplastic opening tool and starting at the top of the camera, work your way around the camera's body and release the tabs holding the front bezel to the chassis. The tabs should require almost no effort to separate.
[* black] The bottom of the camera is a little trickier to get apart. It is held in place by three tabs on the lens side of the camera. Using an iPoda plastic opening tool or spudger, work your way along the seam while gently lifting up on the bezel. It may take a few tries to get all of the tabs to release.
[* black] Using a spudger or iPodplastic opening tool and starting at the top of the camera, work your way around the camera's body and release the tabs holding the front bezel to the chassis. The tabs should require almost no effort to separate.
[* black] The bottom of the camera is a little trickier to get apart. It is held in place by three tabs on the lens side of the camera. Using an iPoda plastic opening tool or spudger, work your way along the seam while gently lifting up on the bezel. It may take a few tries to get all of the tabs to release.
[* yellow] Once the tabs have been released, the front bezel will simply lift off the camera. The approximate locations of the tabs are indicated by the yellow boxes.