Ga door naar hoofdinhoud

Wijzigingen in stap #7

Bewerken voor JaosnT

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Now you will remove all other connectors from the outer parts of the mainboard. as marked in the Red Rectangles. Gently, pull them out of their connection place.
[* black] There is one connector from the mainboard to the little blue board in the bottom righthand corner that is connected on the underside of the mainboard. Just disconnect this one from at the blue board.
[* black] You will find that the two connectors labeled in a yellow rectangle are not connected to anything leading me to believe that this mainboard may be used with other model projectors as well.
[* black] Remove the five screws marked in the red Circles from the mainboard.
[* black] In the Third image you will find the LCD Ribbon Cable on the Center of the Board. You will remove thesethe three of the cables by gently pulling up on either side of the tiny brown connectors attching them to the board
[* black] In the Third image you will find the LCD Ribbon Cable on the Center of the Board. You will remove thesethe three of the cables by gently pulling up on either side of the tiny brown connectors attching them to the board