Ga door naar hoofdinhoud

Wijzigingen in stap #7

Bewerken voor JaosnT

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Now you will remove all other connectors from the outer parts of the mainboard. as marked in redthe Red Rectangles. Gently, pull them out of their connection place.
[* black] TheYou will find that the two markedconnectors labeled in with a yellow have nothingrectangle are not connected to themanything leading me to believe that this Boardmainboard may be used onwith other Models.model projectors as well.
[* black] Remove the five screws marked in the red Circles from the mainboard.
[* black] In the Third image you will find the LCD Ribbon Cable on the Center of the Board. You will remove these by gently pulling up on either side of the tiny brown connectors attching them to the board
[* black] Now you will remove all other connectors from the outer parts of the mainboard. as marked in redthe Red Rectangles. Gently, pull them out of their connection place.
[* black] TheYou will find that the two markedconnectors labeled in with a yellow have nothingrectangle are not connected to themanything leading me to believe that this Boardmainboard may be used onwith other Models.model projectors as well.
[* black] Remove the five screws marked in the red Circles from the mainboard.
[* black] In the Third image you will find the LCD Ribbon Cable on the Center of the Board. You will remove these by gently pulling up on either side of the tiny brown connectors attching them to the board

Afbeelding 1

Oude versie

Nieuwe versie

Afbeelding 3

Geen vorige afbeelding

Toegevoegd