Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #4

Bewerking door Andrew Optimus Goldheart

Bewerking goedgekeurd door Andrew Optimus Goldheart

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] While still pullingholding the glass up with the suction cup, insert a wide plasticslide the point of an opening toolpick into the gap created between the front panelglass and rear casebody of the iPad.
[* icon_caution] Don't insert the opening pick any deeper than the black bezel on the side of the display. Inserting the pick too far may damage the LCD
.
[* black] LeavePull the opening tool insuction cup's plastic nub to release the gapvacuum seal and remove the suction cup from the iPad.
[* black] Unlike in the iPad 2,3, and 4, there is no plastic
display bezel on the iPad Mini. Insert the plastic opening tool into the crack between the front panel and the rear caseassembly.
[* black] While still pullingholding the glass up with the suction cup, insert a wide plasticslide the point of an opening toolpick into the gap created between the front panelglass and rear casebody of the iPad.
[* icon_caution] Don't insert the opening pick any deeper than the black bezel on the side of the display. Inserting the pick too far may damage the LCD
.
[* black] LeavePull the opening tool insuction cup's plastic nub to release the gapvacuum seal and remove the suction cup from the iPad.
[* black] Unlike in the iPad 2,3, and 4, there is no plastic
display bezel on the iPad Mini. Insert the plastic opening tool into the crack between the front panel and the rear caseassembly.

Afbeelding 1

Oude versie

Nieuwe versie

Afbeelding 2

Oude versie

Nieuwe versie

Afbeelding 3

Oude versie

Nieuwe versie