Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #3

Bewerking door Andrew Optimus Goldheart

Bewerking goedgekeurd door Andrew Optimus Goldheart

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] RemoveCarefully place a suction cup halfway up the iOpener from the iPad.
[*
heated side.
[*
black] Place a suctionBe sure the cup is completely flat on the bottom right of the front panel glass, just above the lower bezel and near the right edge of the devicescreen to get a tight seal.
[* black] WithWhile holding the iPad down with one hand on the devicehand, pull up on the suction cup enough to open a small gap betweenslightly separate the front panel glass andfrom from the rear panelcase.
[* icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you may risk cracking the glass
.
[* black] RemoveCarefully place a suction cup halfway up the iOpener from the iPad.
[*
heated side.
[*
black] Place a suctionBe sure the cup is completely flat on the bottom right of the front panel glass, just above the lower bezel and near the right edge of the devicescreen to get a tight seal.
[* black] WithWhile holding the iPad down with one hand on the devicehand, pull up on the suction cup enough to open a small gap betweenslightly separate the front panel glass andfrom from the rear panelcase.
[* icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you may risk cracking the glass
.

Afbeelding 1

Oude versie

Nieuwe versie

Afbeelding 2

Oude versie

Nieuwe versie

Afbeelding 3

Geen vorige afbeelding

Toegevoegd