Ga door naar hoofdinhoud

Wijzigingen aan stap #2

Bewerking door Andrew Bookholt

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_note] This step requires working with both hands and may be better accomplished with the logic board sitting in your lap.
[*
black] Insert wisdom hereUsing an iPod opening tool (or similar) in one hand, push down one pin holding the heat sink on the logic board. The spring under the pin will provide moderate resistance.
[* black] While holding the pin down from the heat sink side of the board, use a pair of pliers to squeeze the two barbs against the plastic post.
[* black] While squeezing the barbs together, push the pin through its hole in the logic board.
[* black] Repeat this process for each of the four pins holding the heat sink on the logic board
.
[* icon_note] This step requires working with both hands and may be better accomplished with the logic board sitting in your lap.
[*
black] Insert wisdom hereUsing an iPod opening tool (or similar) in one hand, push down one pin holding the heat sink on the logic board. The spring under the pin will provide moderate resistance.
[* black] While holding the pin down from the heat sink side of the board, use a pair of pliers to squeeze the two barbs against the plastic post.
[* black] While squeezing the barbs together, push the pin through its hole in the logic board.
[* black] Repeat this process for each of the four pins holding the heat sink on the logic board
.