Ga door naar hoofdinhoud

Wijzigingen in stap #6

Bewerken voor Brady Cabe

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] PROCEED WITH CAUTION!!! The antenna cable and the battery contacts are soldered onto the board.
[* black] Your monitor should look like this, with a small gap between the main board and the rear casing.
[* black] The next step will merely free the volume control dial from the casing and NOT free the main board from the casing.
[* black] The next step will merely free the volume control dial from the casing and NOT free the main board from the casing.
[* black] To remove the main board from the casing, you MUST desolder the antenna cable and two battery contacts from the board.

Afbeelding 1

Geen vorige afbeelding

Toegevoegd