Ga door naar hoofdinhoud

Wijzigingen aan stap #5

Bewerking door Daniel

Bewerking goedgekeurd door Daniel

Voor
Na
Ongewijzigd

Stap regels

-[* black] Use wrench and slowly tighten the nut until it is about half a turn from touching the wheel.
-[* icon_note] Be careful not to cross-thread the axle nut. If turns become too difficult, you may need to unthread the nut to straighten it and then proceed with tightening.
+[* icon_note] Center the second bearing over the where your inserted the spacer and press down until the bearing rests in place.
+[* black] The bearing's outside edges should be flush with the the inside bottom edge of the wheel